This ESC preloaded AM32 custom firmware. It s optimized for crawler and makes your car run super smooth and quiet, but it is also suitable for a variety of 1/8 scale or smaller cars. A built-in adjustable four voltage BEC with a maximum current 10A to apply the high torque servo. In addition, the e-Switch that comes with it avoids failures caused by harsh environments.

All wires are pre-soldered.

Feature

AM32 custom firmware

Sinewave startup allows the motor smoothly at ultra-low speeds Variable drive frequency

Low voltage, throttle loss and stalled rotor protection

High-performance 32-bit MCU

E-switch with long life and waterproof

Specs

Product Num.: A3100

Battery: 2~8S Lipo

Current: 80A cont.

BEC: max 10A, output 5.2~8.2V adjustable by DIP switch

Waterproof: ESC not supported / e-switch supported

FAN: not include, solder pads for power is reserved

Connectors: not include

Wires: battery 14AWGx150mm, output 14AWGx150mm, signal 250mm and e-switch 120mm

Dimensions: 60x29x15mm (without wires)

USB-Link

Suitable for a variety of ESCs, such as AM32/BL32, etc., connect ESC to computer for configuration or upgrade firmware.

It is portable and easy to use, just connect the ESC signal plug, connect the USB Type-C cable to the computer and install the VCP driver.